The JCOM1939 Monitor Software is the perfect tool for monitoring, recording, analyzing, and simulating SAE J1939 data traffic. It works in combination with our SAE J1939 gateways.
This comprehensive, easy-to-use, and easy-to-understand Windows software displays SAE J1939 data traffic. It allows network scanning, simulating an ECU (including full node address negotiation features), and responding to data request messages.
This video provides a brief overview without delving into too much detail to give you a general idea of the program’s capabilities.
The software offers much more than just receiving and transmitting; we will post more videos on this channel. Meanwhile, to explore the whole set of capabilities, please read the user manual on this website.
SAE J1939 Starter Kit and Network Simulator
Our JCOM.J1939 Starter Kit and Network Simulator is designed to allow the experienced engineer and the beginner to experiment with SAE J1939 data communication without the need to connect to a real-world J1939 network, i.e., a diesel engine. To establish a network, you need at least two nodes. That fact applies especially to CAN/J1939, where the CAN controller will shut down after transmitting data without receiving a response. Therefore, our jCOM.J1939 Starter Kit and Network Simulator consists of two J1939 nodes, namely our jCOM.J1939.USB, an SAE J1939 ECU Simulator Board with USB Port.
The jCOM.J1939.USB gateway board is a high-performance, low-latency vehicle network adapter for SAE J1939 applications. The board supports the full SAE J1939 protocol according to J1939/81 Network Management (Address Claiming) and J1939/21 Transport Protocol (TP).
Comments are closed.